Close
1 2 12
1 20 27
  1. #1

    Sep 2016
    28

     ,WJ

    WJ 2003 CRD.
    , L , H .
    , L .
    D N N H ( ).
    , 20 ' D , ( ).
    L , .
    :
    P0700-
    P0702-
    P0340-
    P0703-
    P0836-
    P1685- .

    .
    .
    ?

  2. #2

    Mar 2003
    23,591

     : ,WJ

    h ?


    Jeep ZJ V8 98
    Honda EX300 94

  3. #3
    omri_t's Avatar
    Jun 2005
    4,572

    .
    .
    ...
    ...

  4. #4
    grand's Avatar
    Jan 2003
    3,044

     : ,WJ

    , wj shift modul

    Sent from my SNE-LX1 using Tapatalk

  5. #5
    ..'s Avatar
    Oct 2018
    715

     : ,WJ


    https://jeepswj.com/tips/

    /?

    Grand Cherokee WJ 2.7 CRD
    Sent from my mobile excuse typos

  6. #6
    tom1105's Avatar
    Jul 2010
    1,372

     : ,WJ

    , , . ( )

    Sent from my SM-G950F using Tapatalk

  7. #7

    Sep 2016
    28

     : ,WJ

    ,

    .
    .
    ...
    .


  8. #8

    Mar 2014
    502

     : ,WJ

    ___
    ,

    .
    .
    ...
    .

    , .
    .

    OBD ?

  9. #9
    tom1105's Avatar
    Jul 2010
    1,372

     : ,WJ

    ' '


    Sent from my SM-G950F using Tapatalk

  10. #10

    Mar 2003
    23,591

     : ,WJ

    ___
    ,

    .
    .
    ...
    .

    High ?

    3 , 4 5 ?




    Jeep ZJ V8 98
    Honda EX300 94

  11. #11
    tom1105's Avatar
    Jul 2010
    1,372

     : ,WJ

    Crd - 3 .
    3

    Sent from my SM-G950F using Tapatalk

  12. #12

    Mar 2003
    23,591

     : ,WJ

    :
    http://www.wjjeeps.com/faultcodes.htm

    .
    .
    ".




    P0700 Check Transmission DTC's This code indicates that the EATX (Transmission controller) has an active fault and has illuminated the MIL via a BUS message. The specific fault must be acquired from the EATX via a DRBIII tool. (Input or Output Speed Sensor failures often cause this code and are a common failure part on WJ Grand Cherokees).
    P0702 Transmission Control System Electrical
    P0836 Four Wheel Drive (4WD) Switch Circuit Four wheel drive (4WD) muxed switch input detected below minimum or above maximum acceptable voltage (switch status provided to engine module from transfer case module during 4WD low gear engagements)
    P1685 Skim Invalid Key The engine controller has received an invalid key from the SKIM.
    P0340 Camshaft Position Sensor A Circuit (Bank 1 or Single Sensor) A rationality error has been detected for loss of camshaft position sensor (no fuel sync). WJ 1999 &' 2000: Check the camshaft target wheel (located on the right side camshaft sprocket) for damage or excessive runout. The runout is very critical for proper camshaft signal input to the JTEC. The lateral runout on the target wheel should not exceed 0.012 inch.
    P0703 Brake Switch Stuck Pressed or Released Incorrect input state detected in the brake switch circuit. (Changed from P1595).

  13. #13

    Mar 2014
    502

     : ,WJ

    boaz avrahami
    :
    http://www.wjjeeps.com/faultcodes.htm

    .
    .
    ".




    P0700 Check Transmission DTC's This code indicates that the EATX (Transmission controller) has an active fault and has illuminated the MIL via a BUS message. The specific fault must be acquired from the EATX via a DRBIII tool. (Input or Output Speed Sensor failures often cause this code and are a common failure part on WJ Grand Cherokees).
    P0702 Transmission Control System Electrical
    P0836 Four Wheel Drive (4WD) Switch Circuit Four wheel drive (4WD) muxed switch input detected below minimum or above maximum acceptable voltage (switch status provided to engine module from transfer case module during 4WD low gear engagements)
    P1685 Skim Invalid Key The engine controller has received an invalid key from the SKIM.
    P0340 Camshaft Position Sensor A Circuit (Bank 1 or Single Sensor) A rationality error has been detected for loss of camshaft position sensor (no fuel sync). WJ 1999 &' 2000: Check the camshaft target wheel (located on the right side camshaft sprocket) for damage or excessive runout. The runout is very critical for proper camshaft signal input to the JTEC. The lateral runout on the target wheel should not exceed 0.012 inch.
    P0703 Brake Switch Stuck Pressed or Released Incorrect input state detected in the brake switch circuit. (Changed from P1595).

    ,

    ,
    http://jeepswj.com/software/


    ...
    70

    , ,

    ,
    tom1105
    .


  14. #14

    Sep 2016
    28

     : ,WJ

    ,

    3 .
    , .
    OBD -, .
    .
    , ( ).
    , ?

    .

    , L , .


  15. #15

    Mar 2003
    23,591

     : ,WJ

    .



    Jeep ZJ V8 98
    Honda EX300 94

  16. #16
    tom1105's Avatar
    Jul 2010
    1,372

     : ,WJ

    700 702


    Sent from my SM-G950F using Tapatalk

  17. #17

    Jan 2019
    30

     : ,WJ

    , .... WJ CRD 2004 .

    , .... H L .... H L.. ... 100-200 - ( ).. (ABS, ..) ( )... 2X4 ( ) H L .... 0702, 0703, 0836 ... 4X4 .... ? ?


  18. #18
    tom1105's Avatar
    Jul 2010
    1,372

     : ,WJ

    smarg
    , .... WJ CRD 2004 .

    , .... H L .... H L.. ... 100-200 - ( ).. (ABS, ..) ( )... 2X4 ( ) H L .... 0702, 0703, 0836 ... 4X4 .... ? ?

    ?

    Sent from my SM-G950F using Tapatalk

  19. #19

    Jan 2019
    30

     : ,WJ

    ... ( )... ... 4x4 .... ....

    Sent from my MI 6 using Tapatalk

  20. #20
    tom1105's Avatar
    Jul 2010
    1,372

     : ,WJ

    smarg
    ... ( )... ... 4x4 .... ....

    Sent from my MI 6 using Tapatalk


    Sent from my SM-G950F using Tapatalk

  1. 4X4
    : 18
    : 17-02-17, 13:55
  2. - gv 98
    Aflalo Suzuki
    : 5
    : 09-12-16, 21:10
  3. - '
    alisirh //
    : 4
    : 04-07-13, 06:56
  4. ?? "" . ?
    _ Toyota
    : 6
    : 20-01-13, 13:38
  5. !!!
    bruno 24 Suzuki
    : 7
    : 24-03-09, 00:56

  •