h ?
Jeep ZJ V8 98
Honda EX300 94
WJ 2003 CRD.
, L , H .
, L .
D N N H ( ).
, 20 ' D , ( ).
L , .
:
P0700-
P0702-
P0340-
P0703-
P0836-
P1685- .
.
.
?
h ?
Jeep ZJ V8 98
Honda EX300 94
, wj shift modul
Sent from my SNE-LX1 using Tapatalk
https://jeepswj.com/tips/
/?
Grand Cherokee WJ 2.7 CRD
Sent from my mobile excuse typos
,
.
.
...
.
:
http://www.wjjeeps.com/faultcodes.htm
.
.
".
P0700 Check Transmission DTC's This code indicates that the EATX (Transmission controller) has an active fault and has illuminated the MIL via a BUS message. The specific fault must be acquired from the EATX via a DRBIII tool. (Input or Output Speed Sensor failures often cause this code and are a common failure part on WJ Grand Cherokees). P0702 Transmission Control System Electrical P0836 Four Wheel Drive (4WD) Switch Circuit Four wheel drive (4WD) muxed switch input detected below minimum or above maximum acceptable voltage (switch status provided to engine module from transfer case module during 4WD low gear engagements) P1685 Skim Invalid Key The engine controller has received an invalid key from the SKIM. P0340 Camshaft Position Sensor A Circuit (Bank 1 or Single Sensor) A rationality error has been detected for loss of camshaft position sensor (no fuel sync). WJ 1999 &' 2000: Check the camshaft target wheel (located on the right side camshaft sprocket) for damage or excessive runout. The runout is very critical for proper camshaft signal input to the JTEC. The lateral runout on the target wheel should not exceed 0.012 inch. P0703 Brake Switch Stuck Pressed or Released Incorrect input state detected in the brake switch circuit. (Changed from P1595).
,
,
http://jeepswj.com/software/
...
70
, ,
,
tom1105
.
,
3 .
, .
OBD -, .
.
, ( ).
, ?
.
, L , .
.
Jeep ZJ V8 98
Honda EX300 94
, .... WJ CRD 2004 .
, .... H L .... H L.. ... 100-200 - ( ).. (ABS, ..) ( )... 2X4 ( ) H L .... 0702, 0703, 0836 ... 4X4 .... ? ?
... ( )... ... 4x4 .... ....
Sent from my MI 6 using Tapatalk